Symulator Itnc 530 Upd -

You don't need a PhD. Here is the workflow to simulate any program on the iTNC 530:

Do you use the iTNC 530? What is the worst crash you caught using the simulator? Let me know in the comments below. symulator itnc 530

Select the .H file you want to run. Press the SIMULATION START soft key (often the third from the left). The control will immediately begin to draw the toolpaths. You don't need a PhD

But even the best controller in the world cannot prevent a crash caused by a bad fixture offset or a missing tool length. symulator itnc 530